Technical data
Inserting the Sled-Mounted DLT2000XT Tape Drive
15
Be sure you read and understand the information in “Checking and Setting the Drive’s
SCSI ID” and “Inserting the Sled-Mounted DLT2000XT Tape Drive” sections before you
install the DLT2000XT tape drive in your deskside system. If a full-height drive bay is
already available in the unit, skip to step 5.
Follow these instructions to install a full-height front loading device:
1. Carefully remove the plastic side panel by first grasping the bottom edge of the
panel, as shown in Figure 2-5.
Pull the panel away from the chassis until the ball and socket fasteners release.
Carefully set the panel aside.
Figure 2-5 Pulling Off the Side Panel and Removing the Retaining Screw
Drive shelf
retaining screw