Technical data

20
Chapter 2: Installing the Sled-Mounted DLT2000XT Tape Drive
4. Place two of the jumpers on the H2 middle pins (as seen from the top), as shown in
Figure 2-9.
Installing the Tape Drive
Note:
Be sure you have read and understood the information in “Checking and Setting
the Drive’s SCSI ID” before you install the DLT2000XT tape drive in your rack system.
This procedure requires a short-shaft #2 Phillips-head screwdriver.
Configure your Challenge or Onyx SCSIBox 2 for the DLT2000XT tape drive by following
these steps:
1. Open the lower front door of the chassis and ensure that the system is powered off.
2. Open the door to the SCSIBox 2 by releasing the two wing nuts, as shown in
Figure 2-10.