HP VPN Firewall Appliances Network Management Configuration Guide

628
Device Interface IP address
Firewall GigabitEthernet 0/4 192.168.3.2/24
2. Configuration procedure
a. Assign an IP address and subnet mask to each interface according to Figure 344. (Details not
shown.)
b. Configure OSPF on the routers in the PIM-
DM domain to make sure they are interoperable at
the network layer. (Details not shown.)
c. Enable IP multicast routing, IGMP, and PIM-DM:
# On Router A, enable IP multicast routing globally, enable IGMP on Ethernet 1/1, and enable
PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
# Enable IP multicast routing, IGMP, and PIM-DM on Router B and Router C in the same way.
(Details not shown.)
# Enable IP multicast routing on the firewall, and enable PIM-DM on each interface.
<Firewall> system-view
[Firewall] multicast routing-enable
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim dm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/2
[Firewall-GigabitEthernet0/2] pim dm
[Firewall-GigabitEthernet0/2] quit
[Firewall] interface gigabitethernet 0/3
[Firewall-GigabitEthernet0/3] pim dm
[Firewall-GigabitEthernet0/3] quit
[Firewall] interface gigabitethernet 0/4
[Firewall-GigabitEthernet0/4] pim dm
[Firewall-GigabitEthernet0/4] quit
d. Verifying the configuration
Use the display pim interface command to display PIM information on each interface. For
example:
# Display PIM information on the firewall.
[Firewall] display pim interface
VPN-Instance: public net
Interface NbrCnt HelloInt DR-Pri DR-Address
GE0/1 0 30 1 10.110.5.1 (local)
GE0/2 1 30 1 192.168.1.2 (local)