HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

journalPoolID=-1
thpType=-1
consumedCapacityInKB=-1
thpPoolID=-1
threshold=-1
tcaPoolID=-1
thpPoolVolControlFlag=-1
*****: The value is encoded by the CLI.
ModifyPool
ModifyPool expands a THP pool or changes the settings related to the THP pool.
NOTE:
• This command can be used only with P9500 and XP24000/XP20000.
• The attributes of the Pool instance, thresholdVolForewarn and thresholdVolOverwarn,
which were output as the execution results of this command, have changed to overProvision-
ingWarning and overProvisioningLimit, respectively. Check and, if necessary, revise
the script settings that you use in version 6.3 or later.
To expand a THP pool, the following conditions must be satisfied:
• The conditions on logical units to be specified as pool volumes, which are listed in “Ad-
dPool” on page 66.
• For P9500 and XP24000/XP20000, the status of the THP pool is not Blocked and the usage
rate is not 100%.
For P9500 and XP24000/XP20000, the following conditions must be satisfied if you want to change
the settings related to a THP pool:
• If the status of the THP pool is Normal, the usage rate is less than 95%.
• When changing the threshold value, you specify a value that is larger than the value set for the
usage rate of the THP pool at that time.
Format for P9500
When the command is used to expand a THP pool:
hdvmcli [URL] ModifyPool [options]
model=model serialnum=serial-number
poolid=pool-ID
adddevnums=device-number-of-logical-unit
[threshold=THP-pool-threshold-1]
[threshold2=DP-pool-threshold-2]
[threshold2mode={0|1}]
[overprovisioningwarning=over-provisioning-warning-threshold]
[overprovisioninglimit=over-provisioning-limit-threshold]
[tiercontrol={enable|disable}] [automigration={enable|disable}]
[migrationinterval={0|1|2|4|8|24}]
[monitorstarttime=start-time-of-performance-monitoring]
[monitorendtime=end-time-of-performance-monitoring]
[monitoringmode={0|1}]
Command reference182