Software Instruction Manual

Toolkit utilities 55
Error code Error message Comment or clarification
2834 Invalid logical drive. —
2835 Logical drive not specified.
The script file has commands that require a logical drive, but
no logical drive is specified.
2836
New logical drive ID does
not match the next available
logical drive ID.
The script file specifies a logical drive ID that is not the first
unused ID in the sequence. For example, this message
appears if the controller has only logical drive 1 and the
script file specifies creation of logical drive 3 (omitting logical
drive 2). A common cause of this error is that the input file
specifies nonsequential logical drive numbers. In this case,
change the logical drive numbers in the input file so that they
are sequential.
2837
New logical drive ID
already exists.
This error occurs in Configure mode when the logical drive ID
specified in the script file already exists in the configuration.
In Configure mode, you can create only new logical drives.
2838 Cannot create logical drive.
The array has no free space, or the maximum number of
logical drives has already been reached.
2839
Cannot migrate logical
drive RAID.
The controller does not support RAID migration, or migration
is not possible with the current controller configuration.
2840
Cannot migrate logical
drive stripe size.
The controller does not support stripe size migration, or
migration is not possible with the current controller
configuration.
2841
Cannot extend logical
drive.
The controller does not support extension, or the current
controller configuration cannot be extended. For example,
extension is not possible if the array has no free space.
2842 Invalid RAID.
The specified RAID level is invalid or is not possible with the
current configuration.
2843 Invalid size.
The specified size is invalid or is not possible with the current
configuration.
2844 Invalid stripe size.
The specified stripe size is invalid, or not supported by the
current RAID level, or not possible with the current
configuration.
2845 Invalid sectors.
The specified MaxBoot setting is invalid or is not possible
with the current configuration.
2846
Cannot change logical
drive sectors.
You cannot change the MaxBoot setting on a configured
logical drive because doing so causes data loss.
2847
Invalid array accelerator
setting.
The specified array accelerator setting is invalid or is not
supported by the current configuration.
2848
Cannot change logical
drive array accelerator
setting.
You cannot change the array accelerator setting for the
current controller configuration.
2849
Invalid
ClearConfigurationWithDat
aLoss parameter.
—
2850
Controller does not support
RAID Array ID.
—