Reference Guide

Chapter 4 SCSI Commands
LOG SENSE Command (4Dh)
DLT-S4 Interface Reference Guide 91
General Purpose
Non-Volatile Log Page
(38h)
4
Log page 38h provides access to a 64 byte non-volatile buffer in the tape
drive for general purpose use. The log page contains one 64 byte
parameter with a Parameter Code setting of 0. The 64 bytes in the
Parameter Value field contain the data from the Parameter Value field the
last time a
LOG SELECT command was processed that contained page
38h.
Time Stamp Power-on hours when
CHECK CONDITION status occurred. This is the number of
power-on hours since the last time the drive was powered on, not total number of
hours during the lifetime of the drive.
The time stamp counter is updated once per hour. If the drive is powered down
before the hourly update occurs, the update does not occur until a full hour after
power is re-applied.
Media ID Internal media identifier being used when
CHECK CONDITION status occurred. A
value of 0 indicates no media or unknown media when the event occurred. Note
that this is not a legitimate method of tracing media.
Sense Key The Sense Keys are described table 173
on page 308.
Additional
Sense Code
The Additional Sense Codes are described in table 174
on page 309.
Additional Sense
Code Qualifier
The Additional Sense Code Qualifiers are described in table 173
on page 308.
Additional Error
Information
Not used.
Field Description