Instruction manual

8. USAGE EXAMPLE

IMR01Y06-E6

8.5 Sample Program

 Program conditions

Station number of COM-JC: 1

Number of Occupied station/Extended cyclic:

1 station occupied 1 time (2 controllers assignment)

Automatic refresh device assignment: Refer to 8.4 Device Assignments Example (P. 84).

Special relay (M) assignment: M0: Extension number setting flag for display

M1: Measured value (PV)/Manipulated output value (MV1)

transfer

M2: Extension number setting flag for setting

Data register (D) assignment: D0: Measured value (PV) store of controller 1

D1: Measured value (PV) store of controller 2

D2: Manipulated output value (MV1) store of controller 1

D3: Manipulated output value (MV1) store of controller 2

 Program operation

1. Store Measured value (PV) and Manipulated output value (MV1) to a data register.

2. Write in Set value (SV) of controller 1 and Set value (SV) of controller 2.

Controller 1 set value (SV): 150 °C

Controller 2 set value (SV): 200 °C

3. Change the controller to the control RUN.