Installation Instructions

After selecting one of the above options, press the SET(MODE) key to resync, and the

display will return to normal mode. Do not press any buttons until the synchronization is

complete. The remote search icon will display constantly for 3 minutes until the

signal is reacquired.

7.5ResetMin/Maxrecord

Note: If you own more than one thermo-hygrometer sensor, the minimum and

maximum value of all channels will be cleared in the reset mode.

In normal mode, press (do not hold) the MIN/MAX/-key, the MAX icon will be displayed

in date area. Press the SET/MODE key to view max values of rainfall (rate, 24h, week or

month) , pressure (ABS or REL),outdoor temperature and humidity((AT or dew

point),indoor temperature and humidity (temp or dew point) and sensor temperature and

humidity, sensor dew point or heat index.

Press the MIN/MAX/- key for three seconds to clear all max values. （the rainfall, wind

speed, wind gust, pressure, temperature and humidity maximum values. The maximum

values will now display the current values）.

Press the CHANNEL/+ button to switch the display between remote thermo-hygrometer

sensors 1 through 8 to view Max values.

Press the MIN/MAX/- key again (do not hold), the MIN icon will be displayed. Press the

SET/MODE key to view min values of pressure (ABS or REL), outdoor

temperature/humidity((AT or dew point),indoor temperature/humidity(temp or dew point),

sensor temperature humidity, sensor dew point(dew point or heat index).

Press the MIN/MAX/- key for three seconds to clear all min values.(the pressure,

temperature and humidity minimum values. The minimum values will now display the

current values).

Press the CHANNEL/+ button to switch the display between remote thermo-hygrometer

sensors 1 through 8 to view Min values.

Press the SNOOZE key to exit the min/max checking and cleaning mode, return to normal

display mode.

7.6 Snooze Mode

If the alarm sounds, and you wish to silence the alarm, press the SNOOZE key, the

backlight will turn on. The alarm icon will continue to flash and the alarm will silence for

five minute. press any key (MIN/MAX/+ ,SET/MODE, ALARM,CHANNEL/+) to

permanently exit the Snooze mode.

7.7BacklightMode

If the LED is off, Press the SNOOZE button once. The backlight will turn on for five

seconds, and if no operation is performed for three seconds, the backlight will turn off.

The backlight operation is different when operating on batteries to save power.