X25AM Programming Manual

Index
X25AM Programming Manual—527201-001
Index-4
I
ITI application (continued)
CONTROL 11
waiting for a call 2-23, 2-26
CONTROL 12
disconnect a call 2-26
CONTROL 12 - disconnect a call 2-25
CONTROL 17 - make a call 2-23, 2-26
control packet types 2-9
data forwarding 2-16
data processing 2-16
data transmission from the terminal 2-3
default interrupt characters 2-16
file-system interface 2-2
file-system procedures 2-2
framing characters 2-18
initiating a call 2-3
ITI protocol 1-2
OPEN 2-26
packetizing data 2-17
PAD
parameters 2-10
processing data 2-16
programming 2-20
programming example 2-45
programming task
Clear Diagnostic codes 2-24
clearing the call 2-25
counting 64-byte segments 2-25
counting page-mode terminal
errors 2-25
getting reason call was clear 2-24
opening a subdevice file 2-20
posting a call request 2-23
reinitializing SETMODE
values 2-22
reinitializing SETPARM values 2-22
requesting a clear 2-25
Reset Diagnostic codes 2-24
Restart Diagnostic codes 2-24
ITI application (continued)
retrieving Call Request
information 2-22
setting Call Request
information 2-23
setting I/O processing options 2-21
setting terminal control
options 2-21
setting X.25 network options 2-22
timing page-mode timeouts 2-25
waiting for an incoming call 2-23
READ 2-5, 2-26
remote terminal 2-2
remote terminal access 2-1
SETMODE 10 - parity checking 2-21,
2-28
SETMODE 11 - BREAK ownership
access mode 2-21, 2-28
SETMODE 12 - terminal BREAK
access mode 2-21, 2-28
SETMODE 20 - echo mode 2-22, 2-29
SETMODE 22 - binary line speed 2-21,
2-29
SETMODE 24 - data parity
generation 2-21, 2-30
SETMODE 27 - spacing 2-22, 2-31
SETMODE 28 - reset parameters 2-22,
2-31
SETMODE 31 - first packet size 2-21,
2-31
SETMODE 32 - call negotiation
parameters 2-22, 2-31
SETMODE 38 - line termination
character 2-21, 2-33
SETMODE 6 - line spacing 2-22, 2-26
SETMODE 7 - automatic linefeed 2-22,
2-27
SETMODE 8 - terminal operating
mode 2-21, 2-27
SETMODE 9 - interrupt
characters 2-21, 2-27