User manual

SPrint User Manual ◆ 53
USING THE ACCESSORIES
To connect an FM cable to your SPrint, follow the
steps below.
1. Check that the FM system is working. To do
this, connect earphones to the FM receiver and
ask someone to listen while the FM transmitter
is operating. Speech should be clear and
background noise minimal.
2. Set the SPrint sensitivity to 0. Switch the
processor and the FM receiver off.
3. Set the volume of the FM receiver to the
minimum setting, unless it is locked or taped in
a preset position.
4. Adjust the tone and volume controls for the FM
receiver to the settings recommended by your
audiologist.
Note:
Your audiologist may adjust the controls
for you. Once they are set, it is not
recommended they be changed without
consulting your audiologist.
5. Insert the FM cable connector marked with the
FM number into the FM receiver audio output
or headphone socket.
6. Insert the connector marked ‘COCHLEAR’ into
the SPrint external input socket.
7. Switch the speech processor on.
8. Switch the FM transmitter on.
9. Switch the FM receiver on.
10. Adjust the volume of the FM system to the
setting recommended by your audiologist,
unless already preset. It is not advisable to set
the processor’s sensitivity and the FM volume to
their maximum setting.
N02210F ISS4 DO2.qxd 24/4/02 1:12 PM Page 53