Installing MS BackOffice Small Business Server 4.x

112. Click <Finish>. To close the Wizard.

113. Click <Yes>. To reboot system and complete installation.

114. If present, Click <OK> at service control manager dialog box.

115. SBS starts running the Server Console application with a "To Do List" on the

display. You can hide or exit this application if not needed.

116. This marks the completion of the SBS 4.5 installation.

117. SBS may start a "Console Management application". You can hide or exit this

application if not needed.

118. Run the event viewer application. Clear all entries.

119. Shutdown and restart server. Open event viewer again to verify that there are no

errors in the log.

120. Verify server connectivity by using a client on the network to do a ping and data

transfer to a shared folder.

Section 4. Troubleshooting

Tip #1: Warning message for disks with more than 1024 cylinders

If the boot drive is new or just initialized, Windows NT may give a warning message

about disk drives having more than 1024 cylinders during the first reboot from the hard

drive. Windows NT may hang just after the SCSI BIOS or Disk Array BIOS banner.

Fix: In some situations, the Windows NT SBS installation program may detect the hard

drive geometry incorrectly, and thus limit the initial drive partition size to 1024 MB or

hang while rebooting. To correct this problem, perform one-not both-of the following:

(Be sure to enable extended translation for SCSI controllers)

Before starting the Windows NT SBS installation, follow these steps:

A. Boot into MS-DOS.

B. Run FDISK and FORMAT on the boot partition under DOS.

C. Install Windows NT(SBS). During installation, you may delete and resize the

MS-DOS partition created previously.

Alternately:

In the Windows NT SBS installation program: