Wireless Edge Services xl Module Release Notes WS.02.27
Table Of Contents
- Release Notes: Version WS.02.27 Software for the ProCurve Wireless Edge Services xl Module (J9001A) and the ProCurve Redundant Wireless Services xl Module (J9003A)
- Copyright and Disclaimers
- Contents
- Software Management
- Support Notes
- Release WS.02.07
- Reconfigure Management Passwords After a Software Update from Version WS.01.xx to Version WS.02.xx
- Accessing the Web Browser Interface After a Software Update from Version WS.01.xx to Version WS.02.xx
- Configuring Authentication for Web-Users
- Special Characters for the ACL ID Field
- Correction: SNMP v3 Default Password
- Correction: Stations per Radio
- Correction: Stations per Module in a Layer 3 Mobility Domain
- Correction: Disabling TKIP Countermeasures
- Clarification: Setting Intrusion Detection with TKIP Countermeasures
- Release WS.02.07
- Enhancements
- Software Fixes
- Known Software Issues and Limitations
- Back Cover
6
Support Notes
Release WS.02.07
Accessing the Web Browser Interface After a Software Update
from Version WS.01.xx to Version WS.02.xx
The Java applet in the version WS.02.XX software has been updated. To access the Wireless Edge
Services xl Module’s Web browser interface after an update from version WS.01.XX to WS.02.XX
software, you must complete these steps:
1. Clear your browser’s cache.
2. Clear the Java cache.
3. Close the browser and re-open it.
Note
This procedure also applies if you downgrade from version WS.02.XX to WS.01.XX software.
The following instructions explain how to complete the first two steps. It is assumed that you have
already updated the module’s software and reset the module.
Clear the Internet Explorer (IE) Browser Cache
The following steps detail the process of clearing the cache in IE version 6. If you are using a different
version, your steps might vary slightly.
Follow these steps to clear the cache:
1. Open IE.
Figure 1. IE Browser