CLI Reference Guide-R07

Chapter 4 | System Management Commands
Switch Clustering
– 162 –
Example
This example configures a time range for the periodic occurrence of an event.
Console(config)#time-range sales
Console(config-time-range)#periodic daily 1 1 to 2 1
Console(config-time-range)#
show time-range This command shows configured time ranges.
Syntax
show time-range [name]
name - Name of the time range. (Range: 1-32 characters)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show time-range r&d
Time-range r&d:
status: inactive
absolute start 01:01 01 April 2015
periodic Daily 01:01 to Daily 02:01
periodic Daily 02:01 to Daily 03:01
Console#
Switch Clustering
Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. Switches that support clustering can be
grouped together regardless of physical location or switch type, as long as they are
connected to the same local network.
Table 29: Switch Cluster Commands
Command Function Mode
cluster Configures clustering on the switch GC
cluster commander Configures the switch as a cluster Commander GC
cluster ip-pool Sets the cluster IP address pool for Members GC
cluster member Sets Candidate switches as cluster members GC
rcommand Provides configuration access to Member switches PE