Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
ADM-2 Multipoint Supervisor Protocol
Envoy Application Programming Manual—427159-001
7-33
Line-Error Handling
CONTROL Procedure (Send EOT)
Send EOT is used to reset the line following a READ error. The application sends the
EOT sequence by calling the CONTROL procedure and specifying operation 13
(Example 7-17
).
Line-Error Handling
The figures and error code descriptions in this subsection show Envoy line-error
handling for ADM-2 multipoint supervisor protocol READ and WRITE operations.
This subsection includes:
•
Initial READ Operation on page 7-33
•
WRITE Operation on page 7-36
Initial READ Operation
Figure 7-6 shows the action of the supervisor station in response to line conditions on an
initial READ.
Example 7-17. CONTROL Procedure (Send EOT)
CALL CONTROL (fnum,13)
| EOT -->
(CONTROL completes)
error = 0
line state = CONTROL