Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
File-System Procedures
Envoy Application Programming Manual—427159-001
C-29
SETMODE
The threshold value. If the sum of NAKs
received, BCC errors, format errors, and
retries exceeds the threshold, these
statistics are reported on the operator
console. Refer to Appendix D, Statistics
Messages for more detailed information
on operator console messages
22 1 Modifies baud rate (bits per second) for
asynchronous lines
BAUD n
0 = 50
1 = 75
2 = 110
3 = 134.5
4 = 150
5 = 300
6 = 600
7 = 1200
8 = 1800
9 = 200
10 = 2400
11 = 3600
12 = 4800
13 = 7200
14 = 9600
15 = 19200
23 Modifies character size for asynchronous
lines
1 0: 5 bits per character CHAR5
1: 6 bits per character CHAR6
2: 7 bits per character CHAR7
3: 8 bits per character CHAR8
24 1 Modifies character parity for
asynchronous lines
0 = odd parity ODD
1 = even parity EVEN
Table C-5. SETMODE Operation Codes (page 3 of 4)
Operation Parameter Description
Analogous
Modifier