Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-6
Configuring the ProCurve Wireless Edge Services xl Module
Management Interfaces
Determining the Dynamic IP Address or Assigning a Static
Address
Initially, you must access the Wireless Edge Services xl Module through the
CLI of the wireless services-enabled switch 5300xl—either to determine the
IP address that is assigned to the module through a Dynamic Host Configura-
tion Protocol (DHCP) server or to assign the module a static IP address.
By default, the module is configured to receive an IP address through a DHCP
server. If you keep this default setting, you can simply access the CLI and
determine the IP address dynamically assigned to the module. You can then use
this IP address to access the Web browser interface and manage the module.
Alternatively, you can assign the module a static IP address (again through
the CLI).
Access the Wireless Edge Services xl Module CLI. To access the Wire-
less Edge Services xl Module CLI, you must first access the CLI for the wireless
services-enabled switch. You can use one of the following access methods:
■ Serial session
■ Telnet session
■ SSH session
If you are connecting to the wireless services-enabled switch through a serial
session, use the serial cable (5184-1894) that was shipped with the switch.
Then run terminal session software such as Tera Term or HyperTerminal on
your workstation, setting the following parameters for the session:
■ Baud Rate = 9600
■ Parity = None
■ Data Bits = 8
■ Stop Bits = 1
■ Flow Control = None
If prompted for a password, enter the password for either the manager or the
operator user on the wireless services-enabled switch.
Move to the wireless-services context by entering:
ProCurve# wireless-services <slot letter>