Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-22
Configuring the ProCurve Wireless Edge Services xl Module
Management Interfaces
When you are prompted for a password, enter the password for the manager
user on the wireless services-enabled switch.
Accessing the Switch CLI Through a Telnet or SSH Session
You can also use a Telnet or SSH application to access the CLI for the wireless
services-enabled switch. For instructions on establishing a Telnet or SSH
session, see the management and configuration guide for your switch.
Accessing the Wireless-Services Context
To begin configuring the Wireless Edge Services xl Module, you must move to
the wireless-services context in the switch CLI. In essence, the wireless-
services context is a subset of the switch CLI.
To access the wireless-services context, enter this command, either from the
basic, enable, or global configuration mode context:
ProCurve# wireless-services <slot letter>
Replace <slot letter> with the letter for the chassis slot in which the Wireless
Edge Services xl Module is installed. For example, if the module is installed
in slot C, you would enter:
ProCurve# wireless-services c
The CLI prompt shows that you are in the wireless-services context. You
access the context with the same rights that you had in the switch CLI:
ProCurve(wireless-services-C)#
If you had only operator rights to the switch CLI, you would enter the
command from the switch basic mode context and access the module’s basic
mode context:
ProCurve> wireless-services c
ProCurve(wireless-services-C)>
Navigating the CLI
The wireless-services context allows you to configure and manage the Wire-
less Edge Services xl Module. The wireless-services context is organized into
the same contexts used in the switch CLI. When you first access the wireless-
services context, you are at the enable context, which is identified by the #
symbol that follows the “(wireless-services-C)” portion of the prompt.